Im after a manual for a 930EC flasher module by code3.
The module is inside a Ledx 2100 lightbar.
The control module is small and has a 12v+ terminal, ground, output A, output B and flash.
Upon opening the lightbar the 'flash' terminal is constantly powered to 12v+.
Ive tried disconnecting it and also momentarily touching it whilst connected and disconnected and cant seem to scroll through flash patterns.
The led modules themselves also dont change patterns when temporarily shorting tbe trigger terminals on the back.
Any advice appreciated, pictures below.
The module is inside a Ledx 2100 lightbar.
The control module is small and has a 12v+ terminal, ground, output A, output B and flash.
Upon opening the lightbar the 'flash' terminal is constantly powered to 12v+.
Ive tried disconnecting it and also momentarily touching it whilst connected and disconnected and cant seem to scroll through flash patterns.
The led modules themselves also dont change patterns when temporarily shorting tbe trigger terminals on the back.
Any advice appreciated, pictures below.