FedSig Valor / ROC repair question

[TacoMonster]

I have a Valor with a few LEDs out on a particular ROC PCB module. Is there anyone in ELBland that has had success in making repairs, or is this a FedSig only thing?

 

[Dave F]

I know the only one here thats done them was @wilsonbr90 , but IIRC he had trouble with them and to that end wouldnt do it again, sadly I think your best bet is to go the FS route

 

[TacoMonster]

Thanks @Dave F - the boards are off to FedSig who said they may make repairs as a courtesy if the issues are component failures rather than normal wear and tear, abuse, etc. They’ll decide upon arrival.

I have to say FedSig customer service answered the phone within seconds, was helpful, knowledgeable and issued an RMA fast.

They’re not cheap by any stretch of the imagination, but you get what you pay for.

 

[wilsonbr90]

Late to the game. I will do all fedsig ROC boards with the exception of the legend platform. Probably just needs a few leds replaced.

 

[Cop]

I also would repair Valor but unfortunately I'm in Germany. I've done full conversion with additional LEDs on my valor an still have parts. You should check the LEDs and transistors.
Good luck

 

[TacoMonster]

Thanks all - even though the bar itself is almost 6 years old, FedSig replaced both ROC boards free because they had both been RMAed previously under warranty … and - bonus - the new replacement boards are still covered 5 years from their late 2022 manufacture date.

Federal isn’t cheap - but the service is fantastic.

Mods: ok to lock.