Argent S2 LED lightbar questions and parts needed.

[Leslie Bush]

Good Evening Everyone. I picked up a Fed Sig Argent S2 lightbar last night. Here is what I have 2 10ga wires self explanatory Red (+) & Blk (-). Then a CAT5E Cable That's it.
If I'm understanding the information I've read and the YouTube videos I am going to need a Federal Signal Serial Interface Module.

Does anyone have either New or Tested Used one for sale?
Also can anyone advise on a suggested or suggestion of a control panel/switching setup for this bar.

As always Thank You in Advance for your time and assistance.

Les

 

[SEPD_52]

Good Evening Everyone. I picked up a Fed Sig Argent S2 lightbar last night. Here is what I have 2 10ga wires self explanatory Red (+) & Blk (-). Then a CAT5E Cable That's it.
If I'm understanding the information I've read and the YouTube videos I am going to need a Federal Signal Serial Interface Module.

Does anyone have either New or Tested Used one for sale?
Also can anyone advise on a suggested or suggestion of a control panel/switching setup for this bar.

As always Thank You in Advance for your time and assistance.

Les

These are usually all over eBay. This is one that is currently listed.

As far as what type of switching - that's totally up to you because the SIM converts the data into separate input wires. That said, to get the most out of the bar's functionality I'd get any switching device that allows a progressive 3 or 4 position "slide" switch and up to 6 on/off toggle buttons for things like the takedown, left and right alleys, directional arrow, dimming, etc.