hello guys. im new to the whole lightbar biz but i just obtained a Codse 3 mx7000. i had done some tesing and was able to activate the top driver/passenger rotators(Red wires), the center rotators(Blue wires), and the intersection rotators(white wires). these were easy by crossing 12v from ground to the respective wire. now the bar is equipped with 2 sets of strobe tubes located in the ends. ( believe that is the proper names) when they wouldn't turn on i opened it up to find the thing only had the wiring harness to the running rotators. the tubes were just sitting there disconnected. from what i could find im missing a strobe powersupply to run these, from what i can gather the outputs go the the strobes. ground to ground and positive to battery positive obviously. but then theres this 3 wire control plug that i have no idea where it goes to. i cant find any helpful documentation that tells me what i need to geth this bar fully functional again. any help would be greatly appreciated