So here was my problem,
This was the first 'nice' vehicle I have owned, and I refused to DRILL into plastic.
I had to come up with a radio mount.
I found there is a significant gap between the center island and the bottom of the dash/console area.
I fabricated a square "U" bracket as seen below, and was able to slide it into place.
This allowed me to mount two radios, without making holes.
The weight of the radio, and quasi-sharp edges of the bracket hold them into place as secure as anything else.
Yes I'll move the dash light cig-cable shortly... forgot it was there!
This was the first 'nice' vehicle I have owned, and I refused to DRILL into plastic.
I had to come up with a radio mount.
I found there is a significant gap between the center island and the bottom of the dash/console area.
I fabricated a square "U" bracket as seen below, and was able to slide it into place.
This allowed me to mount two radios, without making holes.
The weight of the radio, and quasi-sharp edges of the bracket hold them into place as secure as anything else.
Yes I'll move the dash light cig-cable shortly... forgot it was there!